# Net overlaps pin

**URL:** <https://community.sparkfun.com/t/net-overlaps-pin/31605>\
**Category:** PCB Design\
**Created:** [September 21, 2015, 9:29pm UTC](https://community.sparkfun.com/t/net-overlaps-pin/31605 "2015-09-21T21:29:05Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Daemach](https://avatars.discourse-cdn.com/v4/letter/d/4af34b/32.png) [@Daemach](https://community.sparkfun.com/u/Daemach)\
**Post date:** [September 21, 2015, 9:29pm UTC](https://community.sparkfun.com/t/net-overlaps-pin/31605/1 "2015-09-21T21:29:05Z")

</div>

I created a part in Eagle by following the tutorial. For some reason, I cannot get it to connect to any nets. Clearly I’ve done something wrong but I can’t figure out what… I stuck with standard grid spacing when I created the symbol.

I’ve attached the schematic file to this post. If you can help me figure this out I would really appreciate it!

---

<div class="post-metadata">

**Author:** ![uChip](https://avatars.discourse-cdn.com/v4/letter/u/ee7513/32.png) [@uChip](https://community.sparkfun.com/u/uChip)\
**Post date:** [September 22, 2015, 2:33pm UTC](https://community.sparkfun.com/t/net-overlaps-pin/31605/2 "2015-09-22T14:33:36Z")

</div>

You have the pins turned around backwards. Swap them end for end.

- Chip

---

<div class="post-metadata">

**Author:** ![Daemach](https://avatars.discourse-cdn.com/v4/letter/d/4af34b/32.png) [@Daemach](https://community.sparkfun.com/u/Daemach)\
**Post date:** [September 22, 2015, 2:59pm UTC](https://community.sparkfun.com/t/net-overlaps-pin/31605/3 "2015-09-22T14:59:50Z")

</div>

Doh!

Thanks 🙂