# Piezo Vibration Sensor using LM393 as the A/D converter

**URL:** <https://community.sparkfun.com/t/piezo-vibration-sensor-using-lm393-as-the-a-d-converter/35063>\
**Category:** Arduino\
**Created:** [December 13, 2017, 9:27am UTC](https://community.sparkfun.com/t/piezo-vibration-sensor-using-lm393-as-the-a-d-converter/35063 "2017-12-13T09:27:50Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Ray116](https://avatars.discourse-cdn.com/v4/letter/r/2acd7d/32.png) [@Ray116](https://community.sparkfun.com/u/Ray116)\
**Post date:** [December 13, 2017, 9:27am UTC](https://community.sparkfun.com/t/piezo-vibration-sensor-using-lm393-as-the-a-d-converter/35063/1 "2017-12-13T09:27:50Z")

</div>

After purchasing SEN-09196 Piezo Vibration Sensor, I decided the use the below circuit with the help of LM393 as the voltage comparator so that the digital input signal can be sent to the arduino.

 ![](https://canada1.discourse-cdn.com/sparkfun/original/2X/0/01fa4b8a561afa15b051f705dfaf2d4d0a6decb6.jpeg)[https://img.alicdn.com/imgextra/i4/3611 … 121710.jpg](https://community.sparkfun.com/uploads/short-url/huJoB1yo1y9sIrHaoXNvVBE9Tg.jpeg)

However, after I replace the vibration sensor at the position 傳感器, there is no digital output signal come out from the DO pin when I try to deflect the sensor. Can anyone explain the reason? Is it the signal voltage too low for the LM393?

---

<div class="post-metadata">

**Author:** ![Valen](https://avatars.discourse-cdn.com/v4/letter/v/9dc877/32.png) [@Valen](https://community.sparkfun.com/u/Valen)\
**Post date:** [December 21, 2017, 10:56pm UTC](https://community.sparkfun.com/t/piezo-vibration-sensor-using-lm393-as-the-a-d-converter/35063/2 "2017-12-21T22:56:22Z")

</div>

Did you adjust the potentiometer and noticed a change in the output?

---

<div class="post-metadata">

**Author:** ![AntEngi](https://avatars.discourse-cdn.com/v4/letter/a/858c86/32.png) [@AntEngi](https://community.sparkfun.com/u/AntEngi)\
**Post date:** [July 8, 2026, 7:58am UTC](https://community.sparkfun.com/t/piezo-vibration-sensor-using-lm393-as-the-a-d-converter/35063/3 "2026-07-08T07:58:48Z")

</div>

Hi, Ray116! Your problem is absence of bias voltage. Piezo have very big resistance, therefore bias voltage for Your lm393 is near of V+.
