# Qs about cutting PCB and protect silver

**URL:** <https://community.sparkfun.com/t/qs-about-cutting-pcb-and-protect-silver/13570>\
**Category:** PCB Design\
**Created:** [December 8, 2009, 2:24pm UTC](https://community.sparkfun.com/t/qs-about-cutting-pcb-and-protect-silver/13570 "2009-12-08T14:24:37Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Magister](https://avatars.discourse-cdn.com/v4/letter/m/ebca7d/32.png) [@Magister](https://community.sparkfun.com/u/Magister)\
**Post date:** [December 8, 2009, 2:24pm UTC](https://community.sparkfun.com/t/qs-about-cutting-pcb-and-protect-silver/13570/1 "2009-12-08T14:24:37Z")

</div>

I made made a PCB by GP, pretty nicely done! It’s standard FR4 with immersion silver.

On my board there is a kind of daughterboard with 3 buttons that you can separate from the main board to position the buttons elsewhere.

I did not have v-score made, so I am wondering what’s the best tool to cut it? I have a Dremel with a couple of cutting accessories like the [[420 wheel](http://www.dremelstore.us/dremel41.html) or the [[426 wheel](http://www.dremelstore.us/dremel15.html), is it ok?

Also I read somewhere that silver can either tarnish or oxidize, can I put something on it? a kind of sealant?

TIA :D]([Loading...](http://www.dremelstore.us/dremel15.html))]([Loading...](http://www.dremelstore.us/dremel41.html))

---

<div class="post-metadata">

**Author:** ![leon\_heller](https://yyz1.discourse-cdn.com/sparkfun/user_avatar/community.sparkfun.com/leon_heller/32/7602_2.png) [@leon\_heller](https://community.sparkfun.com/u/leon_heller)\
**Post date:** [December 8, 2009, 2:31pm UTC](https://community.sparkfun.com/t/qs-about-cutting-pcb-and-protect-silver/13570/2 "2009-12-08T14:31:23Z")

</div>

I’ve got some boards with a silver finish and they haven’t tarnished in a couple of years.

The Dremel should work. I score the material deeply on both sides with a Stanley knife and snap it, then clean it up with a file.

---

<div class="post-metadata">

**Author:** ![theatrus](https://avatars.discourse-cdn.com/v4/letter/t/a8b319/32.png) [@theatrus](https://community.sparkfun.com/u/theatrus)\
**Post date:** [December 10, 2009, 6:47pm UTC](https://community.sparkfun.com/t/qs-about-cutting-pcb-and-protect-silver/13570/3 "2009-12-10T18:47:23Z")

</div>

GP uses a fairly good OSP coating on the silver, which prevents tarnishing. However, if you handle the boards a lot your finger acids will eat that away.
