SparkFun OpenLog Artemis multi sensor logger board failures

[PaulZC]

Hi Nate (@NateSP ),

Posting your question twice won’t get you a quicker reply…

Let’s continue at:

OLA DEV-16832 board multi sensor logger failure

Hi All, I’ve been working on project where I want to log imu / gyro data to determine motions (pitch, roll, and yaw) and accelerations to compare against speed. I have had repeated OLA failures and I am at a loss to understand why. Process/ sequence as follows: Components: SparkFun OpenLog Artemis (OLA DEV-16832) * Ublox Zed F9P * Sparkfun Micro Oled Sparkfun qwiic I2C MUX *donates initial setup, other components added later with AI code input My first attempt used the initial setup only. All raw data was logged on SD card and post processed to obtain the required variables. I discovered an issue with “drift” and the quality of data was quite noisy which made post processing difficult. My research suggested I use a Mahony filter and proceeded with this in mind. My programming skills are limited and have heavily relied on AI (I have used multiple sources to cross check output). When I upload the code (through IDE 2.3.6) I experience an ola failure immediately. This has just hap…

Best,
Paul