OK, I asked this question over at Cirrus’s ARM forum, but who knows if it will ever get responded to. Basically, I have an EP9301 development board from Olimex, and I have a parallel FIFO from IDT (72V2105) that I want to read into the 9301. I know that with some chips, you could put other devices on the memory bus and access them like RAM. Does anybody have any idea how I would go about doing this on the EP9301? I know that the memory bus pins aren’t broken out, so most likely I would have to roll my own board to do it, but I’m just wondering if it’s even possible.