Breakout Board w/ Connector and Battery for GS406 uBlox GPS

I was thinking about making this one myself, and guessing theres probably some other people interested as well:

A Small (Tiny) PCB w/ [SMD connector and [backup battery for [GS406 uBlox GPS which would break out to .1" pads.

-Todd](50 Channel GS407 Helical GPS Receiver - GPS-09436 - SparkFun Electronics)](http://www.sparkfun.com/commerce/product_info.php?products_id=337)](50 Channel GS406 Helical GPS Receiver - SMD Connector - GPS-09079 - SparkFun Electronics)

I would be very interested in a breakout board, although I am sure not the best way soldering wires to the pads on the connector for this is very difficult. Shoot me an email if you decide to make one, I would be interested in buying one.

jwhicks at mtu.edu

Seems that theres not enough interest generated during about a week in this thread for sparkfun to hop on this themselves, so I suppose next time I run a board through batchPCB (With my current project I estimate 2-3 weeks), I will include a few of these breakout boards I described as well.

-Todd

Resurrecting an old-ish topic here. Todd: did you ever get around to making the PCB you described above? If you did, and have extras, I certainly would be interested in buying one off you.

Thanks,

David