Crossworks, STM32F103 dev board, and Standard Periph Lib...

Development Boards MicroMod
1

Hi all,

Well, I have Crossworks for ARM, the STM32F103 board from SFE, and have located the STM Standard Pheriph Lib…Does anyone have a cheat sheet to setup the lib with crossworks? I installed their support package, and it sets up a dir tree etc., I can see where to put the samples, and when I compile all hell brakes loose! :cry:

So, can anyone point me to the right area?

~Kam (^8*

2

Take a look at this thread - it should help you get going.

http://rowley.zendesk.com/entries/10384 … ld-be-used