Hello, I am hoping I could get some suggestions on what I may be doing incorrect on getting these two devices communicating. https://www.tindie.com/products/smartbee/esp32-data-logger-wrtc-sd/ and SparkFun VR IMU Breakout - BNO086 (Qwiic) - SparkFun Electronics. I have tried many combinations, libraries, boards, and sketches. some I can get it to see the 0x4B and/or 0x4A addresses and even had the info showing on the serial monitor but everything was reading zero. I have been trying all kinds of things but the one correct thing to get it to work and I have loads of time trying, I have definitely learned a lot 
. Any help would be greatly appreciated.
I’m not familiar with the SmartBee products, but we have a guide for the IMU here that covers library installation and the like, have you had a chance to go through it? (you might need to adjust pin #’s for the SmartBee)