GM862 How to send email

GPS/GNSS Development Boards
1

I’m using GM862 from: http://www.sparkfun.com/commerce/produc … ts_id=7917 and am trying to figure out how to send an email. I found this on another post in the forum:

at+cgdcont=1,"IP","wap.cingular" 
OK 
at#userid="wap@cingulargprs.com" 
OK 
at#passw="CINGULAR1" 
OK 
at#pktsz=300 
OK 
at#dsto=50 
OK 
at#sktto=90 
OK 
at#sktct=600 
OK 
at#sktsav 
OK 
at#esmtp="cwmx.com" 
OK 
at#eaddr="phonenumber@cingular.com" 
OK 
at#esav 
OK 

at#gprs=1 
+IP: 10.108.211.23 

OK 
at#gprs=0 
OK 
at#emailact=1 
OK 
at#emaild="youraddr@yourhost","GM862 message",0 
> Hello World!<ctrl-Z> 
OK

I’m using an ATT SIM and am unable to find a username / password that would be used for the corresponding AT commands.

I was hoping somebody could give me some insight.

Thanks,

~kb

2

The user ID and password listed work with the AT&T email service “cwmx.com”. Just cut / paste each line, substituting your email address where it says “youraddr@yourhost” and you should get an email from the module to that address. :smiley: