I need someone to test my source-code on Chipcon modules

Wireless & IoT
1

Hello,

I need someone to test my firmware on their own hardware. I am building my own chipcon modules but I can’t get them to work. So, I don’t know if the problem is in my hardware or in my software.

The source is GCC for ATmega16/32…

I just need someone to simply read a few registers from CC11xx chips so that I know that my source code is OK.

I need this because I get some strange results when reading registers, I don’t quite get the “default registers values” :cry:

My hardware: http://www.elektronika.ba/cc1101_done.jpg

Source code: http://www.elektronika.ba/MyModem2.rar

Related post: viewtopic.php?t=10204

Thanks a buch :stuck_out_tongue:

2

I have solved my problem. It was in 5V<->3.3V converter resistor network.

This post can remain here since someone could use the source code provided in the link above.