specifically for this item :
Jennic 802.15.4 Node/sku: WRL-00768
Does anybody know the cable pinout/schematic for programming via the 2x3 idc connector?
Besides the tx/rx @3v3 there is a program pin - what does that need ( rts/cts or something else altogether ? for using jennic IDE and flash programmer )
cheers
Most all of their info is on their website.
I have one of their systems if you can’t find the info.
Thanks, I am kind of new to this - looked through most of their text documentation, but was not sure.
Will see if I can go through the schematics and figure it out.