I am new at this so please bear with me. I designed a board with Eagle and sent it in for fab. The board came back fine but some of the silkscreen information on the top was missing. The component outlines were fine and the text I added was OK. What was missing is the component values and designations…I.E. R22, 450 ohms and other components. I think it may some option I left out when creating the CAM files. I just realized after looking at the gerbers they were missing. My fault for not looking closer before ordering but I still do not know what I left out or did wrong…Any info appreciated.
You know that the gerber files lacked the info. So your problem is with Eagle rather than BatchPCB. Your question would be better asked in PCB Design Questions.
…