nRF52840 is not connecting the computer

Development Boards MicroMod
1

Hi,

I assemble the nRF52840 processor onto the MicroMod ATP Carrier Board. I plug this into my computer via a USB cable. The carrier board is powered on, but the nRF52840 is not connecting as my computer do not detect any external device connecting to it. Any suggestion on this?

Thank you in advance for the help

2

Are you using the USB-A or USB-C port? Its default state is meant for USB-C, try that 1st…then be sure to go through the steps here https://learn.sparkfun.com/tutorials/mi … ware-setup to install the board definitions/drivers - then you should be good-to-go!