First post noob here…
I followed the RFID tutorial and am running it stacked on an UNO. I’m getting gibberish (⸮⸮⸮⸮⸮⸮ҙ+t-<⸮s⸮⸮⸮⸮⸮⸮⸮wа⸮⸮⸮3⸮⸮⸮⸮⸮⸮/t%В⸮⸮) sent back to my serial monitor (Arduino IDE). The baud rate is set to 38400. Not sure where to go from here… any help would be appreciated! Thanks!
Embarrassed now that I found I was using the wrong baud rate… Now to figure out how to delete the original post…
I was actually having the same issue as well. What is the proper baud rate to use? Thank you in advance!
EDIT: Lol nvm. I’m just as embarrassed.
No need to delete. Don’t be ashamed, it happens, A LOT. We’ll leave this here to help guide the poor souls reading the language of our alien overlords.
Truly, thank you for posting!
What had me confused was that the nano was configured to run at 38400, but the software serial was set at 115200.
