Stuck on Running Motor Test Code

Qwiic System
1

Hi all

Following on from my problem outlined here - viewtopic.php?f=105&t=58385 , I am struggling to figure out why the Testing the Motors code on https://learn.sparkfun.com/tutorials/ho … driver/all is not working for me.

When I run it, it gets stuck on printing “ID mismatch, trying again” in the serial monitor.

I have tried using the commands shown in Example 2 further down the page but it doesn’t do anything.

Any help would be appreciated.

Thanks

2

Turns out my SCMD library was not up to date. Updating it fixed the problem