Clone the SPE function board, but it doesn't work

Development Boards MicroMod
1

Shortly after powering on, MICROMOD enters hardfault mode.

https://drive.google.com/file/d/1eQdpzX … drive_link

I show you the troubleshooting process to see if I have missed any details.

  1. Power-on timing

https://drive.google.com/file/d/18chYOV … drive_link

https://drive.google.com/file/d/1bRFyYR … drive_link

https://drive.google.com/file/d/1l38HCp … drive_link

https://drive.google.com/file/d/1WGLry_ … drive_link

  1. Connection Diagram

https://drive.google.com/file/d/1VLdA_u … drive_link

  1. SPI

The cloned SPE function board can read the phyid as 0x0283BC91.

https://drive.google.com/file/d/1z_OjyA … drive_link

Compared with the normal board, the SPI communication is inconsistent between the cloned board and the normal one.

BAD:

https://drive.google.com/file/d/1UKhVmx … drive_link

GOOD:

https://drive.google.com/file/d/1PzwPwM … drive_link

Please help, where is the problem?

2

None of your images are showing.

There’s an eeprom on the board, did you clone it’s contents too?

3

It was my negligence and the picture was not shown.

A 25MHz crystal oscillator can also start.

eeprom is also cloned into the board. It seems that eeprom is not used in the example.

hardfault mode

77.png
77.png333×545 1.88 KB

1.Power-on timing

11.png
11.png886×604 742 KB

22.png
22.png895×539 652 KB

https://drive.google.com/file/d/1l38HCp … drive_link

https://drive.google.com/file/d/1WGLry_ … drive_link

  1. Connection Diagram

https://drive.google.com/file/d/1VLdA_u … drive_link

  1. SPI

The cloned SPE function board can read the phyid as 0x0283BC91.

https://drive.google.com/file/d/1z_OjyA … drive_link

Compared with the normal board, the SPI communication is inconsistent between the cloned board and the normal one.

clone:

https://drive.google.com/file/d/1UKhVmx … drive_link

normal:

https://drive.google.com/file/d/1PzwPwM … drive_link