Hi, I have some difficulty connecting the IMU http://www.sparkfun.com/products/9184 to ArduinoMEGA.
Is there advice for me? my english is not good - I dont understand technical stuff…
thanks
E.
anyone?
Connect power to the board, it says it can take up to 10v.
Connect RX on the Mega to TXD on the IMU.
Connect TX on the Mega to a resistor voltage divider, and output of voltage divider to RXD on the IMU.
Example… TX Mega → 10K resistor(r1) → RX IMU → 20K Resistor(r2) → Ground
Too many genius’ here to answer a simple question…
:twisted: