Drill Too Small in line... (Error)

I’m getting the following error when I try out my board… To my knowledge, I’m not using a drill of that size anywhere in the board. Any ideas why this drill would be showing up in the file, and how (if it’s not being used) to get rid of it?

I’ve attached my DRD file from Eagle v4.15 for reference.

Thanks,

Jeff

Drill Too Small in line: T01C0.0197

%

M48

M72

T01C0.0197

T02C0.0236

T03C0.0320

T04C0.0360

T05C0.0400

T06C0.0440

T07C0.0900

%

T01

X4152Y3653

X4644Y3653

X5136Y3653

X5628Y3653

X6120Y3653

X6612Y3653

T02

X6352Y5861

X5382Y6661

X4832Y6771

X4082Y7131

X2782Y6561

X4132Y10971

X4732Y11471

X5332Y12971

X6332Y11271

X5942Y9911

X6332Y9071

X7082Y9961

X7172Y8531

X8402Y10311

X7432Y12971

X6832Y17271

X4032Y15571

X4032Y14971

X8082Y6261

X10532Y3071

X9832Y2371

T03

X10542Y2571

X10542Y4471

T04

X5874Y5061

X5874Y5841

X4890Y5841

X4890Y5061

T05

X9692Y5981

X9692Y8541

X9692Y9781

X9692Y12341

X11472Y12341

X11472Y9781

X11472Y8541

X11472Y5981

X5982Y19161

X4982Y19161

X3982Y19161

X2982Y19161

T06

X4232Y17281

X11232Y19281

X11232Y15281

T07

X3012Y3991

X7752Y3991

M30

[/b]

according to your drill file, you are using that drill 6 times. What happens when you run eagle’s drc? Both tool 1 and 2 should get flagged if you are using the default drill size min (drc/sizes tab) of 24 mil.

It’s probably coming from a 6 pin, 50 mil pitch component at 0.4152,0.3653 - load the component layer into viewmate and then import the drill file. You should see it.

Wow; thanks for the insight… I will check out the board again with what you told me and see what I find.

Thanks again,

Jeff

Yep; you’re exactly right. I didn’t know how to read those things, but now I do! I fixed it and am about to order it in a bit… Thanks much.

Jeff