getting UART baudrate >9600 on AVR-MT-128

Development Boards MicroMod
1

Hello everyone,

I’ve been using the Olimex AVR-MT-128 dev board for two months now, and have a few questions. Perhaps others had similar encounters.

  1. anyone was able to get it to communicate with a PC at baud rate greater than 9600? default code runs @ 9600, but that’s all… Perhaps it’s me?

  2. my “Button #5” stopped working shortly after getting the board. It’s “stuck” in the short position (signal to ground), thus always appearing to be “ON.” Could I have somehow messed it up while resetting fuses? with the board off, the button itself appears to be functioning (tested for continuity fine).

Thanks in advance!

Best regards,

George K.