Help!!!! .. Olimex sam7-ex256 / sam-ice & ethernut / win

Has anyone managed to make work and flash the Olimex Sam7-ex256 dev board with ethernut using a SAM-ICE or uLink?

I have both jtags, I have Keil uVision3 and IAR tools, and i can’t seem to flash the board.

i have found a SAm7-ex256 EK instruction guide on the Ethernut website, but has anyone made any head way??

Please help me. I am doing my dissertation on Ethernet for my university project and I am struggling to get any further. I need to make a webserver working, so that i can send UDP packets from the 3 Olimex Board that I have, inorder to investigate the suitability of ethernet.

any help would be appreciated, on any thing to do with either the SAM-ice settings for doing downloading hex or binaries, or the uLink, and ethernut.

I am new to this world, please help.

regards, Lars

Hello Lars,

take a look here:

http://www.yagarto.de/howto/jlink/index.html

This is used in the moment only for RAM debugging.

Take a look at this page too:

http://www.ethernut.de/en/documents/sam-web-radio.html

A SAM7X board is using here too.

Perhaps these pages can help you.

By the way, could you remove the sticky attribute?

If everyone make a question sticky, it will be difficult later.

Best regards,

Michael