Hello All,
I have recently purchased the K9202 board and also purchased the Olimex Jtag device for debugging the ARM board.
But i have accidentally erased my NOR flash memory and want to reprogram it by using JTAG.
Does anybody used the Olimex device for programming the NOR flash memory?
More over after installing the OCD i am not able to use it . Can anybody help.
Regards
Arnab
arnabsom:
Hello All,I have recently purchased the K9202 board and also purchased the Olimex Jtag device for debugging the ARM board.
But i have accidentally erased my NOR flash memory and want to reprogram it by using JTAG.
Does anybody used the Olimex device for programming the NOR flash memory?
More over after installing the OCD i am not able to use it . Can anybody help.
Regards
Arnab
Adding to the question posted by me i want to add that i have found out a way to run the openocd in linux by referring to some previous threads in this group. I would like to seek clarification about the config file
I am using kb9202B board and the board contains the AT91RM9200 cpu
Can anybody share the config fle for this cpu.
Arnab