Olimex Board problem

[vijaya_kumar]

Dear all,

I had been Soldered to take out external pins. c61 capacitor came out from that board. That capacitor value is 10pF referred from user manual. i soldered another which has same value. But my nand flash is not booting correctly. Problem with Hardware. Any idea to fix this problem.

This is urgent requirement. Please some oe give your suggestions.

[n1ist]

Which board?

What your additional wires connected to?

I would check your soldering on the “external pins” and on the capacitor you replaced. 10pf sounds like it is probably for a crystal; a short, open, or too long lead length could cause the oscillator to not run or not be on frequency.