Ponyprog's SI programmer

Development Boards MicroMod
1

Hi,

I am using ponyprog’s SI programmer for atmega32. I tried programmig the fuses using avrdude and the programmer. After this my device went bad. I am not able to write anything to the flash memory. Does ponyprog’s SI programmer supports programming the fuse bits or I have to use something else. What could have gone wrong?

Thanks,

Shailendra

2

It works.

Thanks

3

hi, I have the same problem… after set some fuse bits (in ponyprog) my atmega16 stop to read/write, but still work with inside code, programmed before fuse setting. There is a solution?

Thanks.