Setting up FLIR Lepton 3.5, breakout board and raspberry pi

Hi,

I am following this guide to setting up my lepton with the raspberry pi:

https://flir.netx.net/file/asset/41693/ … attachment

However, I am getting stuck on this command: make -j4 zImage modules dtbs

Even after 3 hours, the command doesn’t finish running. Is this normal?

Thanks

Did the “depth=1” command from just before the “make-j4” step get entered successfully? That keeps the build from trying to access all of the unused branches of the repo

It might also be helpful to re-start fresh from the beginning