Hi,
I’m dealing with the same issue, the only difference is that the non responsive IMU appears after updating the firmware to v1.9.
SD init failed (second attempt). Is card present? Formatted?
Config file read failed: SD offline
Artemis OpenLog v1.9
ICM-20948 failed to init.
SD card offline
Datalogging offline
Serial logging offline
IMU offline
Identifying Qwiic Devices…
No Qwiic devices detected
All IMU sensors are enabled. Before the update everything was working just fine.
Grateful if someone can help me to enable the IMU logging again.
Kind regards,
Joanie