Wanted: complex/pretty batchpcb design with simple use...

OK, I thought I’d post here as there are so many makers (and breakers) and/or people who want to create funky stuff.

I have an ?odd? request… If this isn’t the best place please move or remove.

I am looking for someone to make a LARGE pcb design to be sent to batchpcb (or where is cheapest/best) that will contain the logo of our company within the pcb/‘tracks’ and be surrounded by ‘complex looking’ circuits to make it look pretty/geeky/tech (further details to be supplied on request)…

By my terminology it should be clear I know diddly squat about circuit/pcb design :slight_smile: Which is why I would like the circuit to optionally allow me/us to solder on some tri-colour LEDs and an Arduino to it :mrgreen:

I think it would be a great project for someone who has used batchpcb before for ‘simple circuits’ (so we know the led lighting will definitely come out ok/work) but also good for someone who also wants to try out complex PCB design without the cost/risk of making mistakes (because the ‘complex’ part will only be used to look at, not to ‘do’ anything).

I hope that makes sense, feel free to ask questions or give estimates for the design work involved.

Please note that until I know a rough cost for the design + batchpcb + arduino this is just an idea (but the funds are in place if total reasonable).

Batchpcb isn’t the best place to do large boards due to cost; they are really good for small ones. For a large board, you may want to go directly to Gold Phoenix and use their $99 special. A full panel will save you almost $300.

/mike

$99! That’s awesome, I was expecting pcb cost to limit size/options/impact.

I’m basically look for a centre piece for a wall/pic frame/embeded in a meeting table, etc. (should of said earlier).

Now just a question how much someone would charge for a design and a bit of hand holding/help… :slight_smile: