About Artemis logger baudrate

Development Boards Artemis
10

Hi,

I think this is the cause of your issue:

  • I configure a new serail baudrate speed by pressing ‘any key’ + 4 + 4 and then set a configuration, like for example 9600

  • I check the configuration and indeed it appears 9600 bps

  • I reset using the reset button

The baud rate is only saved when you exit the main menu - by entering “x” twice.

Please try:

  • Configure a new serial baudrate speed by pressing ‘any key’ + 4 + 4 and then set a configuration, like for example 9600

  • Exit the menus by pressing x twice

  • Reset using the reset button

I hope this helps,

Paul