ARM Philips 2138 ICP programmer

Development Boards MicroMod
1

Hi,

If somebody have experiences with connecting Logomatic V1.0 (sparkfun electronics) with LPC-ICP programmer?

On Logomatic board exist JP3 connector for connecting with LPC programmer.

My question is:

RX0 and TX0 from JP3 are going to pins 21 and 19 on ARM 2138. Where I can connect RST and BSL pin from JP3 on ARM 2138?

Instead, RST pin on ARM 2138 have own reset (pin 57), what is BSL?

Best regards

2

I have no idea about the specifics of your problem but BSL is a pin that you assert to get the ARM into bootloader mode after a RESET.

It is all documented in the LPC User Guide.

You could just search for BSL on this Forum too for more help.

Good Luck!