Configure 100KHz in LMV358

Hi, you bought the LMV358 board (https://www.sparkfun.com/products/9816), but I have a doubt on how to configure it for the 100KHz sea output

The description reads: “… The bandwidth is set to 15.9kHz by a pair of feedback capacitors, or over 100kHz with the caps removed …”,

My question is this: how do I remove the caps?

I would like to see an image with the caps removed.

Thank you very much for your help.

Stay tuned to any comments

Regards

Matias Alvarez Sabate

Hello matialvarezs.

I don’t have a photo with the capacitors removed, but the picture below show which ones need to be removed.

You would need to desolder them from the board to remove them.

Ok thanks, but ufff, difficult task, regards

Matialvareze, if you don’t have soldering iron experience I suggest cutting the traces with an exacto knife (or any very sharp knife).

Regards,

Kevin