ETT-ARM Stamp Olimex JTAG working under OpenOCD

Development Boards MicroMod
1

Hi,

I have working config files for getting the ETT-ARM Stamp running under OpenOCD if anyone is interested.

I am using the Yagarto tools/eclipse ide etc. and the Olimex ARM-USB-OCD

I can send a simple ‘flashing LED’ project to anyone interested. It allows burning to the ARM’s flash, and debugging under gdb

Probably not an optimal setup as I have only been using OpenOCD for about a week, so still an amateur!

The amount of effort it cost me, I’m sure this must be valuable for other newbies trying to program this device

Cheers

Glenn

2

Hi,

I intend to buy the same environment that you have.

I’m interested by your experience about this hardware and your arm tool chain.

Regards,

Vincent