Help With Eagle

Archive BatchPCB
1

I am trying to get my board to pass DRC, but there are a few vias that are having clearance and drill issues. I do not understand what is wrong. Would anyone be willing to take a look if I sent the board to them? Any help would be very much appreciated.

Thanks,

Kyle

2

ok email them to me, or paste the error message here.

I can go into detail on any error, lol, i built the system

3

Thanks for the reply pittuck. The issue is not your system, but DRC within Eagle. If you are familiar with the DRC through Eagle, I would still very much appreciate your help.

Thanks,

Kyle

4

yup, whats the error?

5

I sent the files to you via email. Thanks again for the help.

Thanks,

Kyle

6

Fixed the errors! Yippee!

7

alangsk:
Fixed the errors! Yippee!

OK, so what was the problem and what was the solution?

-Tony

8

I’m just guessing but sometimes eagle gets the drill size wrong. I think its due to switching between metric and english too many times. Right now, my eagle via drills are just a tad less than .024 (23+ mils). The DRC is set to flag any drill less than .024 by default so ALL my vias flunk DRC and I have to manually fix them. been meaning to dig into this but its just an annoyance for now.