Hello! I am using an arduino giga to power a nextion device, a stepper motor and the HX711 board connected to a s-type load cell. I have everything running correctly. Except the sampling rate is near 10SPS. I see that pin 15 has a way to be able to increase the sampling rate. When I connect it to a …

[image] evanroebke: I see that pin 15 has a way to be able to increase the sampling rate. You open the solder jumper so that the RATE pin is pulled up to VCC; you don’t tie the pin directly to VCC. [SFE_HX711_SampleRate]

HX711 Rate Change Turning Power OFF

Development Boards Arduino

languer October 13, 2024, 3:58am 2

You open the solder jumper so that the RATE pin is pulled up to VCC; you don’t tie the pin directly to VCC.

1 Like

Topic		Replies	Views
Switching HX711 Sampling Frequency to 80Hz Force & Weight	3	1847	February 6, 2020
Increasing sample frequency of HX711 amplifier Force & Weight	2	546	August 21, 2019
Implementing the IoT Scale Tutorial (problem with the HX711 Load Cell Amp) Force & Weight	3	794	September 11, 2019
Time required for serial communication with HX711 vs Qwiic Scale? Force & Weight	1	818	January 1, 2022
HX711 powerdown mode? Force & Weight	1	549	December 28, 2020

HX711 Rate Change Turning Power OFF

Related topics