Issue in X20P firmware update through U-center 2

[Milan_John]

I have tried to do the firmware update on my x20p module by connecting it to u-center 2. The update is not happening. Below I have attached the snippet during the update.

How do i perform the update on the module via u-center 2???

[PaulZC]

Hi @Milan_John ,

It is not possible to update the X20P using its built-in USB interface. It is only possible to update over UART or I2C. Please see the post linked below for more details.

I hope this helps,
Paul

How to update GNSS Flex pHAT - ZED-X20P firmware with u-center 2

I tried to follow the u-blox guide on YouTube to update firmware. The guide was created for the u-blox EVK-X20P evaluation kit, so I tried to follow it the best I could. I can’t get it to work. I connected the USB-C port on the pHat to a USB-A port on my laptop running Windows 11. I can receive satellites. When I try to update firmware, I get a warning after a few seconds that COM5 is disconnected. I see more error messages, and then an traceback for an uncaught JavaScript exception. The only way I can reconnect is to power down the Pi completely and restart. How can I update my X20P firmware?