OpenLog Artemis -- Microphone, Temperature-controlled low power mode

Development Boards Artemis
1

Hi, I am working on a project with the OLA (with IMU) and have a few questions:

  1. I would like to log data from an analog MEMS microphone (BOB-19389). I am currently thinking of doing so by connecting the AUD pin on the mic to the Rx pin on the OLA. because it automatically logs serial data. Does that sound like it would work? If not, is there a better way to do so?

  2. Is there a way to send the OLA into a low power mode based on temperature readings from the IMU?

  3. This may be a really obvious question, but would uploading a script to the OLA mess with the pre-programming?

I’m new to this device and would appreciate any help. Thank you!