OpenLog stuck in loop

Other Miscellaneous
1

I recently started using SparkFun OpenLog (DEV-13712) to log some sensor data.

I have set the config.txt file to boot in command mode.

It was working fine for a couple of hours and I have managed to log a few files.

However, it now fails to go into command mode and transmits “1”.

I have tried the following troubleshooting steps:

  1. Reformatting the SD card

  2. Creating a new config.txt

  3. Emergency reset

2

Try the steps here https://learn.sparkfun.com/tutorials/op … leshooting

Also try swapping a different SD card - any change?