Replacing lost screws. What's the Screw Size for Argon One M.2?

Community Development Platforms
1

Hi all,

Short story is I managed to lose the screws for my RPi4’s Argon One M.2 case. The four that hold the aluminum top to the plastic base fell off my bench and probably down a drain. I’m looking for replacements.

I’ve emailed Argon’s support, it’s been a week no answer yet.

If anyone has this case and can measure I would be very grateful to know what size screws I need to get to replace them.

Thanks

2

So, my unit is also without screws :-p

BUT…I tried a m2.5 screw/bolt and it worked…unsure of the length that it came with, but it works with a 12mm

TL;DR m2.5 x12mm works

3

Here’s the response I got from Argon Tech support:

Please see respective screw sizes for our Argon ONE M.2 case:
 
Bottom plate: 2.5mm thread size x 9mm height
M.2 expansion board screw: 2.5mm thread size x 6mm height
M.2 screw: 2.5mm thread size x 7mm height
Fan screw: 2.5mm thread size x 14mm height
Power board: 2.5mm thread size x 5mm height
V2 bottom plate: 2.5mm thread size x 6mm height