Round PCB

Community PCB Design
1

Hey Everyone,

I am working on a project that requires a round PCB. I’ve read around but after even uploading my Gerber’s to BatchPCB it doesn’t even show it’s round. I have the RGB LED’s hanging over the edge of the board which is what I need, but I can’t figure out how I would let BatchPCB know that I want this board to be round and the part of the LED’s hanging off of the board to be cut off.

Here is my board:

http://iroboticshowoff.com/thinimg/979614.png

Thanks!

  • Alec
2

If you have a board outline they will make the board to that.

It is very common to have legend items overhang the board edge and the manufacturers are used to removing this.

A note on your drill drawing/maufacturing notes would help.