SparkFun JetBot AI Kit v2.0 - Camera Mount Alignment Issues

Kits
1

TS-Brandon:
Can you post a picture of your camera module?

Chiming in here but can post separately if needed. We might be seeing similar issues with camera holder alignment. One issue is with the camera’s mount: the screw heads result in a gap. The other is with mounting the camera holder: the screws holes don’t line up cleanly.

This is a newly purchased KIT-16390.

Photo attached.

jetbot_camera_mounting.jpg
jetbot_camera_mounting.jpg1103×1131 179 KB

2

I split this topic from where it was. They’re kind of about the same part, but different issues with that said part. No need to make another post.