Xbee pro problem

Wireless & IoT
1

Hi everybody,

I’m using two Xbee pro 2.4Ghz with ArduPilot Mega and my PC.

On PC side, I’ve an Xbee Explorer dongle, and I use it to set Xbees up with X-CTU.

I was configuring Xbee #1 with a Baud rate of 57600 and clicked on “write”.

Then, I unplugged the dongle, put Xbee #2 on and plugged into PC.

This Xbee was set with a Baud rate of 38400.

Instead of clicking on “read”, I clicked on “write” again, and here my problem begin :cry:

X-CTU is now unable to connect to Xbee #2…

Here’s what I already tried:

  • Unbricking the Xbee using [this tutorial: X-CTU message: Getting modem type… Programming modem… Lost communication with modem… Write parameters failed

  • Saving the profile of Xbee #1, plugging Xbee #2, loading the profile and click on “write”: no success, same message as above

  • clicking on “restore”: X-CTU message = Resetting AT commands… Restore Defaults cancelled by user

Does someone have an idea of the way I would go? :roll:

Thanks!

Bastien](Google Code Archive - Long-term storage for Google Code Project Hosting.)