in Eagle, ratsnest tool is not filling polygon

Community PCB Design
1

Hi everyone, i need a solution.

I completed drawing polygon, i named GND to both top layer and bottom layer, then i clicked ratsnest tool,however, the top layer plane didn’t appear.

Why does that happen?

This is the board.

http://i.stack.imgur.com/8JW7a.png

if you want to see the .brd and .sch files.

https://www.dropbox.com/s/15f0yvmyquhrb … t.brd?dl=0

https://www.dropbox.com/s/utokm8y9g8tas … t.sch?dl=0

i asked the same question here but i still couldn’t figure out the problem.

http://electronics.stackexchange.com/qu … 652_230936

2

Thanks, answer found in stackexchange website.

3

And it was???..

4

Hi,

I agree, it’s totally lame to post ‘I’ve got the answer’ without actually revealing what the answer is! Doing this means that the thread is a dead-end for the next guy, and is essentially useless!!

So… There is a setting that controls this behavior:

From the Eagle toolbar: Options > Set… > Misc, and then check or uncheck ‘Ratsnest processes polygons’.

John M.