Problem using MSPGCC-JTAG with Olimex JTAG-TINY USB

Development Boards MicroMod
1

I can’t connect to my target (olimex board) with my USB JTAG-TINY. I followed the instructions in the “readme” that came with the driver. The readme refers however, to a MSP430.dll in the /mspgcc/bin directory which does not exist! Do I need a special version of the mspgcc-jtag tool? Where can I get it?

BTW: On a different computer I can use my parallel port JTAG, but my newwer computer doesn’t have a parallel port.

Regards,

Bill

2

to the best of my knowledge mspgcc supports ONLY parallel port JTAG and not USB jtags

I send e-mail to mspgcc maintainers about this but without any reply so far

Tsvetan