correct images?

Archive BatchPCB
1

I submitted a test board to see if it would pass, and it did :slight_smile:

These are the images that it were sent back to me, do they look correct? Are the drill holes suppose to be shown???

Thanks,

Steve

http://www.snm-eng.com/pcb1.jpg

http://www.snm-eng.com/pcb2.jpg

2

Only top and bottom copper are shown. No holes, no overlays, just stuff that might kill DRC.

-Nathan

3

thanks for the replies… waited a while for the new site. Can’t wait to get my first board made :slight_smile: already tested my new board, and it passed :slight_smile:

still waiting to decide on a few parts before I am done.

thanks