Drill Holes - Do they show on .png files the DRCBot sends?

Archive BatchPCB
1

Hi all,

I just submitted my first PCB gerber files and DRCbot passed it. I received 5 files back from the bot, 3 of which are .png drawings showing top, bottom and a composite of what the board should look like including silkscreen.

It doesn’t show the drill holes though. Are the holes normally shown in those drawings?

Or did I mess up my gerber drill file?

edited to add:

NVM I found a few posts asking the same thing, drill holes will not show in the .pngs that the bot emails.

2

Hi,

No it does not seem to do so, your files may or may not have good drill files. In my last proto board I got a couple drill holes that were smaller then expected, if I had have been more careful in the design I would have picked up on that.

Well one lives and learns.

C.