DRC Bot error?

Archive BatchPCB
1

I just submitted my PCB design and received a DRC failed error message from the bot. It highlighted a particular trace that said failed the 8mil width and 8mil spacing requirements. I double-checked and the trace is fine. It’s a 10mil trace and I have my Eagle DRC set to 10mil spacing just to be on the safe side and it passes DRC in Eagle.

Any suggestions? I could try to move it around a bit I suppose but it seems like a bot miscalculation…

2

This is definitely a bot error. I changed the trace so it did NOT pass DRC in Eagle (traces very close, almost overlapping), submitted it, and then the bot came back and said it passed DRC. Hmm.